1 white blades speed is not too fast.
2 Doku less coarse white blades open, multi-purpose knife or alloy knife.
3. workpiece is too high, rough opening should be layered with different lengths knife.
4. ensure consistent margin knife only after the rough opening with machetes, knives and then remove excess material applications.
5 flat knife plane applications processed, less ball knife processing, in order to reduce processing time.
6. Doku clearance angle, the angle R to check the size, and then determine how much of the ball with a knife.
7 calibration plane four corners to gong level.
8 where the inclination is an integer, the slope cut machining applications, such as pipe position.
9 do every process before, think clearly after a process before processing the remaining margin in order to avoid excessive air knife or knives processing.
10. try to take a simple tool path, such as the shape, Trench, single, less walking around the contour.
11. go WCUT, can go FINISH, and do not go ROUGH.
12. shape knife, first crude light, then nothing left, when the workpiece is too high, the first light side, and then the light at the end.
13. reasonable set tolerances to balance the machining accuracy and computing time. When open coarse tolerance margin fifth set, when the knife, the tolerance is set to 0.01.
14 steps to do a little more to reduce air knife time. Do a little more thinking, reducing opportunities for error. Do a little more auxiliary plane auxiliary lines, improve the processing conditions.
15. establish a sense of responsibility, carefully inspect each parameter, avoid rework.
16. eager to learn, good at thinking and progress.
Milling non-planar, multi-ball cutter, less side knife, do not be afraid of knives.
Clearance angle knife, sword finishing;
Do not be afraid fill surface, suitable surface can increase the processing speed up and beautify the processing results.
Rough material of high hardness: milling better
Rough material of low hardness: Climb better
Good machine precision, rigidity, finishing: the more adapt climb milling, whereas the more adapt milling
The parts around the corner finishing strongly recommended to use climb milling.
Roughing: milling better, finishing: climb milling better
Tool material toughness, low hardness: the more adapted to rough (large cutting capacity and processing)
Poor tool material toughness, hardness: the more adapted to finishing (cutting small amount of processing)